FlinnStinnett626

The Xbox has already been an amazing package by itself. However, with games like Call of Duty 5, Modern Warfare, and Modern Warfare 2, a lot more people find reasons to get a new said game console, or its accessories. One particular modification can be a reaction to develop a rapid fire modded Xbox 360 console controller. Listed below are the steps on how to modify your original controller to some rapid fire controller.

Step 1. Unscrewing the controller

Xbox 360 modded controllers - Prior to starting taking your controller apart, take a close look at the controller first and try to remember which parts go where because you will eventually must put everything again. Start by unscrewing every one of the visible screws in the dust. Next, prior to deciding to tug on the case, eliminate the batteries to reveal the hidden screws. Remove these also.

Step two. Preparing the truth

With the controller facing down, slowly and punctiliously separate leading 50 % of the casing from your circuit board. A dent in case could eventually need to be made. Remember this before putting things back.

Step 3. Placing The Rapid Fire Button

While other ways of modifying the controller don't involve installing a brand new button, this particular guide does. Not only does this make it easier to adjust the rate of rapid fire, it minimizes tampering with other elements of the circuit board, thereby minimizing the potential risk of damaging your modded Xbox controller.

Xbox 360 modded controllers - Remember, kits for your rapid fire controller can be bought easily. Oahu is the button out of this kit that'll be placed with the hole within the casing, so stick it gently before the circuit board is returned. You might need to snip out a couple of flaps to make method for the wires of the kit. You can do this with either a cutter or perhaps a couple of scissors.

Step 4. Soldering

Assuming that you know how to correctly utilize a soldering iron, attach the red wire to the leftmost pin of the 4-pin horizontal series, even though the blue wire solders to the rightmost pin of the identical series. The black (or green in some instances) wire attaches for the middle of the three vertical series to the right of the switch.

Soldering is easily the most crucial step to making the modded Xbox 360 console controller. This is because mistakes made during this stage can permanently damage your controller.

Step five. Putting everything back

Xbox 360 modded controllers - Carefully being attentive to the wires, try to close the circuit board as well as the casing. Pest little tricky because the new wires are certain to get in the form of things. Discover a way because of these wires to occupy the empty spaces rather than sticking out. You might contain the modded Xbox 360 controller facedown so that the buttons don't fall and maneuvering the wires certainly are a little easier. Place the casings together but don't return the screws yet. Congratulations, you need to check if the rapid fire buttons work. When they don't, you may want to restart both your console as well as the now modded Xbox 360 console controller. This would solve the problem. If it doesn't then you may need to go through the steps again to double check.